SEMI-SMOOTH CEMENT-BASED COATING

Uses and applications

Its mineral content and the controlled granulometry of its materials allow it to be used as a final finish of high quality and beauty. It is applied in thicknesses of no more than 3 mm as a final coat on previously flattened surfaces.

Surface preparation

The surface must be free of dust, oil and badly bonded materials to achieve an adequate adherence. The surface must be sealed with PLASTIBOND 500 or moisten with water before applying the product. If the chosen surface has paint or another badly bonded coating on, consult with our technical department for the solution.

Product preparation

In a clean container, add 14 litres of clean water for each sack of 40 kg, gradually add ESTUCOP INTERMEDIATE®. Manually stir or with an electric mixer until the product is fully incorporated.
Continue stirring until the mixture becomes an evenly paste with the right consistency for its application.

Recommendations

1 to 4 litres of PLASTIBOND 1000 can be added to increase the plasticity of the mortar. Do not add water after the initial mixture. Excess water in the mixture causes a decrease in the quality of the product and compromises the compressive strength of the material. It is recommended to seal the surface with PLASTIBOND 500 or 1000 before applying the product.

Performance

As a final finish on CEMENT RENDER 3 in 1 approximately 9 to 10 sq.m. 3 mm thick.

Presentation

Sack of 40 kg. Colours: white, cream and grey.

Advisory service

Our technical support department is at your service for the solution of any problem within our range.
The instructions given in the present sheet are based on our broad experience. The conditions under the product are managed and the methods of application are off our limits. The users must carry out tests according to their needs.

Data Sheet

Download