ESTUCOP FINE
- Home
- Modified mortars
- ESTUCOP FINE
CEMENT BASED COATING WITH INTEGRATED RESIN
Uses and applications
Its mineral content and granulometry of its ultra-fine components allow it to be used on high quality and beauty finishes, very similar to traditional plaster with the difference of it being stronger for its cementitious base. Applicable indoor and outdoor as final coat on previously flattened surfaces such as concrete, plasterboard or any kind of plasterboard.
Surface preparation
The surface must be free of dust, oil and badly bonded materials to achieve an adequate adherence. If the chosen surface has paint or another badly bonded coating on, consult with our technical department for the solution.
Product preparation
In a clean container, add 8 litres of clean water for each sack of 20 kg, gradually add ESTUCOP FINE. Manually stir or with an electric mixer until the product is fully incorporated. Continue stirring until the mixture becomes an evenly paste with the right consistency for its application.
Recommendations
Prepare only the amount needed. The product hardens after 30 minutes due to its cementitious content. Do not add water after the initial mixture. Excess water in the mixture causes a decrease in the quality of the product and compromises the compressive strength of the material. It is recommended to seal the surface with PLASTIBOND 500 or 1000 before applying the product.
Performance
12 to 15 sq.m. 2 mm thick for a sack of 20 kg
Presentation
Sack of 20 kg. Colours: White, cream and grey.
Advisory service
Our technical support department is at your service for the solution of any problem within our range.
The instructions given in the present sheet are based on our broad experience. The conditions under the product are managed and the methods of application are off our limits. The users must carry out tests according to
their needs.